TA Triumph-Adler DC 2325 - Manual (Page 35)

FAX Operation (Basic)
OPERATION GUIDE 3-3
3
2 Press [On.]
3 Press [OK].
NOTE: In direct transmission, you can designate only one destination for
one transmission.
Memory Transmission (When originals are placed in the document
processor)
After originals placed in the document processor are scanned and stored
in the memory, the receiving system is dialed. This method is very
convenient because you can have originals returned to you without waiting
for sending of the originals to be completed. It is suitable for sending
multiple-page sheet originals.
Memory Transmission (When originals are placed on the glass
surface)
This method is suitable for sending book originals that cannot be placed in
the document processor. After originals placed on the glass surface are
scanned and stored in the memory, the receiving system is dialed.
NOTE: When continuous scan is set, you can continue with scanning of
a next original after an original on the glass surface has been stored in
memory. Every time one page is scanned, you perform an operation to
allow continued scanning, and after all the originals have been stored in
memory, the receiving system is dialed.
Setting for Direct
transmission
Description
Off Starts memory transmission.
After originals are scanned into memory, the
communication starts.
On Starts direct transmission.
Dials the receiving system, and after the
communication has started, originals are
scanned.
Status 10/10/2007 10:00
Enter Destination.
Cancel OK Add Shortcut
Ready to directly transmit FAX.
On Off
FAX Direct Transmission
Destination
Send FAX directly, without reading original
into memory. FAX can also be sent
page by page, with confirmation
after each page.
0
Press [OK] to display
the image.