TA Triumph-Adler DC 2025 - Manual (Page 43)

CHAPTER 5 FUNCTIONS
5-11
Set the original(s).
Touch the [Function] key.
The Function screen will appear.
Touch the [Combine] key.
The [Combine] screen will appear.
Select the combination style by touching the [2 in 1] or
[4 in 1] key.
The layout set-up screen will appear.
1
Inch specifications
Metric specifications
3
Inch specifications
Metric specifications
4
Inch specifications
Metric specifications
5
6
7
8
9
Start
Stop/
Clear
5 6
8 9
0
2
Touch the key corresponding to the desired layout.
Select the type of borderline by touching the [Solid], [Dot-
ted] or [Borders] key. If a borderline is not necessary,
touch the [None] key.
IMPORTANT
• If the message “Select drawer” appears, close the Combine
screen and select the drawer.
Press the [Start] key.
Scanning will start.
When originals are set in the Document Processor, copy-
ing will start after scanning the set originals.
When an original is set on the platen, a message for
scanning the next original appears. Go to the next step.
Replace the original and then press the [Start] key.
Scanning will start.
When all originals are scanned, touch the [Scanning fin-
ished] key. Copying will start.
→ →