TA Triumph-Adler DC 2025 - Manual (Page 32)

CHAPTER 4 BASIC OPERATION
4-8
4. Energy saver (preheat) function
This function turns the machine off to save energy by pressing
the [Energy Saver] (preheat) key, while leaving the main switch
turned ON.
When this function is activated, the Energy Saver (preheat) indi-
cator is the only indicator lit on the operation panel.
To resume copying after the energy saver (preheat) function has
been activated, press the [Energy Saver] key again. It takes about
30 seconds for the copier to recover from the energy saver (pre-
heat) function.
NOTE
• The auto energy saver function can be set to trigger after no
copying has been done for a certain period of time. (See “Auto
preheat time” on page 6-17.)
2
4
5
6
9
8
7
*
0
#
3
1
*
Management
Interr
upt
Star
t
Stop/ Clear
Energy Sa
ver
Reset
Energy Saver
5. Auto shut-off function
This function automatically turns the main switch OFF (
嘷 ) if no
copying operation is performed for a certain period (15 to 240
minutes). To make copies again, set the main switch to the ON
( I) position.
• Auto shut-off function
The auto shut-off function is a power saving feature which auto-
matically turns the main switch OFF (
嘷
) when a certain time
elapses with out copying being performed.
Copiers are generally in the standby mode more than operation
mode, and power consumption in the standby mode accounts for
a large part of overall consumption. Having the copier turn OFF
(
嘷
) automatically reduces unnecessary power consumption in
the standby mode or at night if the copier is left on. The result is a
lower electricity bill.
NOTE
• To change the time remaining until the auto shut off function
operates, see “Auto shut-off time” on page 6-17. To cancel the
auto shut-off function, see “Auto shut-off ON/OFF” on page 6-
21.