Remote control via rs232, Remote control via rs232 -13 – RIGOL DM3068 User Manual
Page 137

RIGOL
User’s Guide for DM3068
3-13
Remote Control via RS232
1. Instrument Connection
Connect the multimeter to PC using RS232 cable.
2. Configure RS232 Parameters
Select RS232 interface and configure its parameters according to “Interface
Configurations” in chapter 2.
3. Search RS232 Device
Turn on the Ultra Sigma and click
to enter the communication
setting interface shown below. After you configure parameters according to
the instrument serial port parameters (“\r\n” must be selected in End Mark),
click
to test the RS232 communication. When the communication
succeeds, the searched devices are shown in resource list at the right side of
the panel; otherwise, follow the guides to solve the problem.
This manual is related to the following products: