To set the configuration – RIGOL DM3068 User Manual
Page 121

Chapter 2 Front Panel Operations
RIGOL
User’s Guide for DM3068
2-79
To Set the Configuration
Press
System Cfg to enter the following interface.
1. PwrOn
Select a system configuration to be used at power-on from “Default” and
“Last” (configuration at last power-off).
This setting will be available at the next power-on.
The multimeter will always use DCV as the default measurement at every
power-on no matter Default or Last is selected.
2. Default
Restore the multimeter to factory defaults (see Table 2-8).
3. Switch
Enable or disable the front power button. The default status is OFF.
ON: enable the front power button. After turning on the power switch at
the rear panel, users need to press the power button at the front panel to
turn on the multimeter.
OFF: disable the front power button. Users can directly start the
multimeter by turning on the power switch at the rear panel. However,
you can still turn off the multimeter by pressing the power button at the
front panel.
Table 2-8 Factory defaults
Parameter
Factory Default
Measurement Parameters
*Short-circuit Resistance
10 Ω
AC Filter
Mid
DC Input Impedance
10 MΩ
Reading Resolution
6 ½
Measurement Function
DCV