beautypg.com

Remote control via gpib, Remote control via gpib -11 – RIGOL DM3068 User Manual

Page 135

background image

Chapter 3 Remote Control

RIGOL

User’s Guide for DM3068

3-11

Remote Control via GPIB


1. Connect the Instrument

Connect the multimeter to PC using GPIB cable.


2. Configure GPIB Address

Select GPIB interface and configure its address according to Interface
Configurations
in chapter 2.

3. Search RS232 Devices

Turn on the Ultra Sigma and click

to enter the communication

setting interface as shown in the figure below. Click “Search” and the software
will search the GPIB instrument resources connected to the PC. The device
resources will be displayed on the right side of the panel.


If resources can not be found automatically:
 Select the GPIB card address of the PC from the comboBox of “GPIB::”

and select the GPIB address set in the instrument from the comboBox of
“::INSTR”.

 Click “Test” to check whether the GPIB communication works normally; if

not, please follow the corresponding prompt messages to solve the
problem.


4. View GPIB Device

Click “OK” and the software return to its main interface. The searched
instruments are shown under the “RIGOL Online Resource” directory, as

This manual is related to the following products: