Oki ColorPainter E-64s - Manual (Page 85)

85
Layout Problems
 The image was trimmed
When printing the job, the edge of the image is missing.
Action
Check the width of the data and the page size.
Attention: There are areas that cannot be printed on at both edges of the page (deadspace)!
For example, if the media is 54 inches wide (1372 mm), you cannot print a job using the full 54-inch page size.
There is always a deadspace of a few millimeters at both edges.
The value for this deadspace changes according to the presence of color stripes and the edge guard.
Printable area = Page size - Deadspace
z Calculating the area that can be used for printing
Edge guard Color stripes Printable width Remarks
Yes No Page size - 20 mm *
Yes Yes Page size - 43 mm
No No Page size - 10 mm
No Yes Page size - 33 mm
* The internal page size sets the width that can be used for printing with these conditions.
When you want to print a job that uses the full width of the media, you must lay out the job taking into
consideration the deadspace.
The next page introduces how to set a custom page size.