Oki ColorPainter E-64s - Manual (Page 28)

28
What the M-64s can do (2)
Print in the desired time: Control the balance of productivity and quality.
If you use the standard profiles below that are included in RIPCenter installation media, you will be able to print
using all of the M-64s print modes.
Standard profile list
Vivid Natural
1_GlossyVinyl1 Draft Yes Yes
FastProduction Yes Yes
Production Yes Yes
Standard Yes Yes
Quality Yes Yes
High quality Yes Yes
Maximum quality Yes Yes
2_GlossyVinyl2
(For media with poor drying
characteristics)
Draft Yes Yes
FastProduction Yes Yes
Production Yes Yes
Standard Yes Yes
Quality Yes Yes
High quality Yes Yes
Maximum quality Yes Yes
3_Banner1 Draft Yes Yes
FastProduction Yes Yes
Production Yes Yes
Standard Yes Yes
Quality Yes Yes
High quality Yes Yes
Maximum quality Yes Yes
4_Clear1 Production, high density Yes -
Standard, high density Yes -
Quality, high density Yes -
High quality, high density Yes -
Maximum quality, high density Yes -
5_BltBanner1 Production, high density Yes -
Standard, high density Yes -
Quality, high density Yes -
High quality, high density Yes -
Maximum quality, high density Yes -
6_BlueBack1 Draft Yes -
FastProduction Yes -
Production Yes -
Standard Yes -
Quality Yes -
High quality Yes -
Maximum quality Yes -
The default settings shared with all the above profiles:
- Print Direction: Bi-Directional
- Move Print Head Image Width: Selected
- Media Advance Value: Do not control from RIP
- Heaters: Do not control from RIP
(These settings can be changed with Mode Options for each media print mode.)
Attention!
Switching the carriage speed and turning the color stripes on/off cannot be set from the RIP.
Configure these settings on the printer panel.