Precision Digital PD6300 - Manual (Page 42)

Model PD6300 Pulse Input Rate/Totalizer Instruction Manual
42
Programming the Rate/Totalizer (prog)
It is very important that one reads the following information before pro-
gramming the meter:

The meter has been factory calibrated to read input frequency in Hz
(pulses/sec). The calibration equipment is certified to NIST stan-
dards.
 Use the K-Factor menu to match the rate/totalizer with a flowmeter’s
k-factor (pulse/unit of measure).
 Or use the Scale menu to scale the pulse input (pulse/sec) without a
signal source.
 Or use Cal menu to calibrate the rate/totalizer using a signal source.
The Program menu contains the following menus:
1. K-Factor calibration
2. Scale without a signal source
3. Calibrate with a calibrated signal source
4. Total time base & conversion factor
5. Grand total time base & conversion factor
6. Total reset mode for total & grand total
The process inputs may be calibrated or scaled to any display value
within the range of the meter.
pr og C al
P r o g
t t b
P r o g
t C F
P r o g
G ra nd
To ta l
Se tt ings
t rs t
P r o g
sC al e
P r o g
FA ct or
P r o g
Additional parameters, not needed for most applications, are pro-
grammed in the Advanced Features menu; see Advanced Features
Menu
, page 70.