MINOURA P-600AL-5S - Manual (Page 5)

- 5 -
Install Top & Bottom Hooks
1
Top Hook for front wheel
Bottom Hook for rear wheel
Install the top hook to the
upper clamp.
Make sure the clamp is
placed between the four
projections on the hook.
Screw the bolt using your
finger at least in the first 3–4
rotations. After confirming
the bolt threads without
any problem, use the tool to
tighten.
(Fig. U)
(Fig. V)
(Fig. W)
(Fig. X)
2
Install the bottom book to the lower clamp.
You don't have to fix the bottom hook. Adjust the tightening
as the hook won't come down by its own weight.
!
It's possible on any threaded mechanism that
the bolt can be forced on at an angle. If this
happens the bolt usually stops in one turn.
If you feel the bolt is threading incorrectly do
not continue or doing so will cause damage to
the thread, possibly destroying it.
Properly threaded bolts will turn easily so
using your fingers to get the bolt started
insures you'll know if the bolt is installed
correctly.
(Fig. T)
Pillar Joint Clamp
Upper Pillar
Lower Pillar
Pillar Joint
Joint the Pillars
The pillars on P-600AL-5S are separated, not a single piece like as
previous model.
Both pillars have same diameter, and the pillar joint fastens the pillars.
The pillar joint has already been installed on the upper pillar.
You insert it into the lower pillar, then tighten the clamps to fix.
1
At first, loosen the clamp on the lower pillar by M5 hex wrench.
2
Insert the pillar joint into the lower pillar.
3 While keeping both pillars are tightly attached, tighten the clamp firmly.
(tightening torque: 8 N.m)
!
Reguraly check if the clamp bolts are securely
tightened. If these bolts have been loosened, the
pillar could be apart and fall down.
8 N.m
Tighten
!
If you apply too much torque for tightening the bolt, the clamp may
be deformed. If the clamp ends touch each other, it no longer works
and you need to replace to a new clamp for your safety.