MINOURA Bike Rest ( Model : PHS-1 ) - Manual

Install the stainless base plate onto the braze-on
on the seat-tube.
You can install it together with the bottle cage.
PHS-1
Extend the leg and fully insert into the arm with
the red soft plastic bush.
Wrap both the rear wheel and
seat-tube with the Velcro strap
so the bike doesn't move when
parked.
●
●
●
●
●
●
●
● A braze-on is required for the stand to be installed
properly.
● Use on flat and level floor or ground. Do not use on any
slanted location.
● Leg size is adjustable in 20mm travel. Depends on the
braze-on height, you may not be able to use PHS-1.
● Do not get on the bike or apply any load to the bike
when using the PHS-1. The leg should be broken.
● Wrap the rear wheel and frame with the supplied Velcro
strap for stability.
● When storing PHS-1 on the frame, tighten the Velcro
tape firmly. If you need to hold on a vertical pipe due to
some reasons, you should put it above the bottle cage
to prevent dropping down.
● Do not ride with the PHS-1 extended.
PHS-1
Bike Rest Model : PHS-1 ‒ instructions manual