MINOURA W-150 - Manual

Bicycle Maintenance Stand W-150 instructions manual
PART NAMES IMPORTANT NOTES
• Use only with standard two wheel bicycles and
e-bikes. Long wheelbase bikes like tandems are
not recommended as they may cause the stand to
become unbalanced.
• Stepping down on the pedal automatically raises
the arm. Make sure your hands and fingers are
clear of the arm when engaging the pedal. Keep
material clear of the pedal so as not to engage the
pedal and arm.
• Set up W-150 on flat and level floor. You won't be
able to keep stability if you place W-150 on slanted
floor, especially when the arm is in up position.
• The gas dampener generates a up to 13 kg of lift. It
moves quickly and with force. Keep a safe distance
when engaging the arm.
• Firmly clamp the bike in the jaws to prevent the
bike from coming off the stand.
• The jaws open/close by pulling up/down on the
clamp lever. When clamping the bike in the stand,
simply pull up on the lever and tighten the yellow
knob in a clockwise direction.
• When rotating the bike on W-150, hold the bike
with your hand. Do not set the bike in wrong
position that the bike's gravity point is located
higher than the clamp jaws.
– 1 –
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone: +81-584-27-3131 / Fax: +81-584-27-7505
[email protected]
www.minoura.jp
Made in Japan
Front Leg
Foot Pedal
Rear Leg
Support Stay
Remote
Cable
Clamp Lever
Knob
Clamp Jaws
Link Arm
Clamp Angle Lock
Release Lever
Protection
Cover
Pillar
e-bike Station (W-150)
Gas Dampener