MINOURA DS-4100 - Manual

Bike Storage Stand
DS-4100
instructions manual
IMPORTANT NOTES
Contact
If you have questions or need help, first contact the shop you purchased the product from,
or the distributor in your country. If you still can't find a solution, contact Minoura directly at:
MINOURA JAPAN (for ALL customers)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone : +81-584-27-3131 / Fax : +81-584-27-7505
Email : [email protected]
www.minoura.jp
Made in Japan
(ver.1.0 2014/10)
●For normal 2-wheel sport bicycle with standard
26-inch or 700c size wheel. Not suitable for any
tandem, long tail or small wheel bicycles.
●The wheel cradle height is adjustable in 3 levels
by changing the side frame installation point.
However, every cradle's height must be in same
level. You cannot change it independently.
The shorter the wheelbase size is, the steeper
the angle will be. It means you should not
store different size bikes such as road bike and
BMX in one stand. The rear tire must touch the
ground.
●The cradle's inner width is 66mm. Any tire wider
than this size cannot be used in DS-4100.
In the case of much narrower road bike tire,
please be sure the wheel will be supported at
3 points on the tire, not by the cradle frame, so
the wheel won't sit an an angle in the cradle.
●The cradle must hold the front wheel. If you set
the bicycle upside down, the bicycle will have to
come off due to the steering mechanism.
●A bicycle with a front mud guard may not fit in
the cradle properly.
●The long, straight tube keeps the rear wheel
from falling through. This bar is not locked and
inserts into the hole, fixing the pillar direction
with the hole facing inside.
●Do not setup on any slanted location. The
stand will not be stable. Adjust all foot adjusters
correctly to be stable.
●You can add 2 more cradles on the other side
as option.
Warranty Period : 1 year
For more details, please refer the attached
"Minoura Warranty Policy" card.
For the latest info, please check out our web site;
www.minoura.jp.