MINOURA 971-3H - Manual

(ver.2.1 2013/7)
!
1,620mm
1,340mm
1,090mm
840mm
920mm
850mm
Bicycle Display Stand 971-3H instructions manual
Thank you for choosing Minoura 971-3H.
Read this instructions carefully to understand
well how this stand is constructed before starting
assembling.
Completed image and dimensions of 971-3H
(in the settings the bikes facing rightward)
IMPORTANT NOTES
• For standard 2-wheel bike only. No recumbent, tandem and any other type of bikes.
• For 24-inch wheel or larger only. Any bike with smaller wheel such as BMX or juvenile bike, and a special bike
with too low bottom bracket height or carbon monocoque frame may not fit to this stand.
• In the case of electric bike, the weight limit is 30 kgs each.
• The bike is supported at just 3 points; front tire, rear tire and the bottom bracket. Adjust the BB Support height
precisely in each case to expect maximum stability.
• The bike direction is fixed as per the Stair Frame direction. Wrong direction cannot mount the bike properly.
• Do not step on this stand. The stand body is not so durable to support your weight.
• Setup this stand on horizontal and level floor, especially when installing the optional Caster Kit.
• When moving this stand, get off all bikes from the stand before action.
• Check regularly if each bolt and nut are firmly tightened.
Contact
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone +81-584-27-3131 / Fax +81-584-27-7505
[email protected] http://www.minoura.jp
Made in Japan