beautypg.com

MINOURA W-3100 User Manual

W-3100, Bicycle maintenance stand, Instructions manual

background image

Bicycle Maintenance Stand

W-3100

instructions manual

Tool Tray (option)

Back Knob

Clutch Release Lever

Upper Pillar

Lower Frame

Right Side Leg

Adjusting Screw

Clamp Adjust

Knob

Clamp Lever

Clamp Jaws

Gear Clutch

Upper Pillar

Holding Bolt

Parts Name

Left Side Leg

How To Assemble W-3100

Required Tools: 1 x 13mm Spanner

1 x 6mm Hex Wrench

1 x 5mm Hex Wrench

Assemble both Legs to the Lower Frame with the
supplied M8x40 bolts and M8 Nuts.

Make sure the Lower Frame direction is that the
thread hole for the Lock Bolt (P-8) is located on the
back side.

M8x40 Bolt

M8 Nut

1

Important Notes

(ver.1.1 2014/4)

• Only for standard 2-wheel bicycle.

Using with a tandem or long-tail bike may loose

balance due to its its length.

Be careful on your back when lifting up heavy

e-bike or DH bike to the clamp jaws of W-3100.

• Setup the W-3100 on a level floor for greater

stability.

• Clamp the bike firmly to make sure it doesn't

accidentally come loose.

However, be careful not to crush the thin tubing

or carbon frame due to too much clamping

power.

• The clamp jaws will open/close via the clamp

lever operation.

Forcing the lever could cause damage to the

lever, linkage, or your bike frame. Hold the bike

by rotating the yellow knob on the lever.

• When turning the bike on W-3100, hold the bike

with your hand then operate.

Keep the bike relatively horizontal in the stand.

Extreme angles may cause the bike or stand to

fall.

Thread hole

located on the

backside