MINOURA EBS-3 - Manual

3-tier bicycle storage stand
EBS-3
instructions manual
(Ver. 1.0 2011/11)
IMPORTANT NOTES
Read this instructions carefully before assembling
to understand how each part should be connected.
• For standard 2-wheel bike including e-Bike. Any other bikes such as recumbent, wheelbase is 920mm or
shorter, tire outer diameter is 320mm or smaller, or tire width is wider than 56mm are not permitted to use
with this stand.
• The ladder frame is constructed durable enough to be capable with the weight of your body and bike for
mounting bike on the stand, but the total weight should be limited up to 100 kgs including bike. And we
recommend to step on or close to the side frame.
• To keep the bike on EBS-3 stable, both wheels must sit in the wheel cradles properly and the front tire must
be held from upside too. If the bike is equipped with fender or rear rack, the bike must be set rightward.
• Setup EBS-3 on flat and level floor. If the floor has been slanted, we don't guarantee the bike stability.
• When need to move EBS-3, you must remove all bikes prior to action.
• Check regularly every bolt and nut is properly tightened. Use correct tools for assembling and maintenance.
Contact
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone +81-584-27-3131 / Fax +81-584-27-7505 / [email protected]
- 1 -
1,800mm
1,680mm
770mm
520mm
270mm
660mm
950mm
1,030mm
400mm
400mm
[completed style and dimensions]
!
Made in Japan