MINOURA P-600AL-5S - Manual (Page 3)

- 3 -
Inside layout is as shown in Fig.F.
You will install short Legs first, so you don't have to
set Long Leg at this moment.
(Fig. F)
4 Put the longer M6x70 Bolt to the end hole on the
Short Leg, then screw it into the Pillar.
(Fig. G)
M6x70 Bolt
Spring Washer
5 Put the shorter M6x45 Bolt into the corner hole to fix
the Long and Short Legs. M6x45 Bolt will be screwed
to the Dome Nut.
M6x45 Bolt
Spring Washer
Dome Nut
6 Tighten every bolt.
Over-tightening the M6x70 Bolt may cause serious
damage to the alloy Pillar. Do not overtighten.
(Fig. H)
(Fig. I)
Assemble P-600 in X-style Leg
Setting up the P-600 in the X-style allows the stand to
1 Put 4 black Collars to the designated holes on the
Long Leg. Sandwitch the Long Leg with 2 Leg
Brackets, then attach to the Pillar.
(Fig. J)
be placed anywhere due
to the larger footprint and
maximum stability of the X.
It also allows you to install
extra optional attachments
on the pillar.
Please note, setting the
stand up in the X-style does
require more floor space.
Pillar Long Leg
Collar
(Black)
M6x45 Bolt
Spring Washer
M6x70 Bolt
Spring Washer
M6x45 Bolt
Spring Washer
Dome Nut
(Fig. K)
Use the longer M6x70 Bolts
to the center 2 holes for
screwing into the Pillar.
Use the shorter M6x45 Bolts
to the outer holes, then screw
to the Dome Nuts.
Every bolt should not be
tightened firmly yet.
This is the image after every bolt is screwed in.
(Fig. L)
(Fig. M)
Leg Bracket
(both are exactly same)
Screw the bolts to
these threaded slots