beautypg.com

MCZ Club AIR User Manual

Page 47

background image

PELLET STOVES

Chapter 4

INSTALLATION AND USE MANUAL

page

47

Operation

Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited

MESSAGE ON

DISPLAY

TYPE OF PROBLEM

SOLUTION

A10

The plug is defective

Contact an authorized service centre to replace the

component.

A11

Defective pellet feeder

Contact an authorized service centre to replace the

component.

A12

The remote control has been beyond the

reception range of the stove for more than

three hours, or its batteries are dead.
NOTE: only in this case the stove does not go

into alarm shutdown, but continues operating

in the mode that the remote control set via the

last sent command.

Move the remote control back to within range of the

stove, or change the batteries if they are dead.
As soon as the stove receives a new signal from the

stove, the alarm indications will disappear. A easy way

to force a transmission to the stove is to press button 4.

This changes operating mode from manual to automatic

and vice versa.

A13

Generic failure of electronic control unit

Contact an authorized service centre to replace the

component.

A14

Generic failure of sensor

This alarm is not blocked, only a warning screen

appears. Contact an authorized service centre to replace

the component.

SEr

Periodic maintenance warning

If this flashing messages appears when lighting the

stove, it means that the hours of operation pre-set

before the maintenance have elapsed and a new

maintenance intervention is necessary. Contact a

specialist MCZ technician.