beautypg.com

Start-up/shutdown from emergency panel, Synchronization of remote control, On off – MCZ Club AIR User Manual

Page 44

background image

PELLET STOVES

Chapter 4

INSTALLATION AND USE MANUAL

page

44

Operation

Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited

D

E

ON

OFF

D

G

6.1. Start-up/shutdown from emergency panel

If the remote control is defective or the batteries are dead, you can

temporarily run the stove from the rear emergency panel.
In this configuration, the stove can operate only in manual mode and

with possibility to select from 3 levels of power.

LIGHTING THE STOVE WITHOUT THE REMOTE CONTROL

To light the stove, place selector “D” to ON. At start-up the red

LED goes off and the green LED will start flashing until the

start-up phase is complete. At full operating power the green

LED will come on steady.

SELECTING POWER WITHOUT REMOTE CONTROL

You can choose from three levels of heating power:
MIN-MED-MAX (selector “E”)
MINIMA power is the 1st power;
MEDIUM power is the 2nd power;
MAXIMUM power is the 3rd power;

SHUTTING DOWN THE STOVE WITHOUT THE REMOTE

CONTROL

To shut down the stove, place selector “D” to OFF.

Once the remote control is working again, remember

to put selector "D" back in the "REMOTE" position.

Otherwise the stove will disregard inputs from the

remote control.

6.2. SYNCHRONIZATION OF REMOTE CONTROL

Upon first start-up of the product, it may be necessary to get the stove

to recognize the new remote control. To carry-out this operation, follow

the simple instructions that follow:

connect the stove to the socket and switch the power supply

button on

ensure that the selector D of the emergency panel is in the

position REMOTE

when the first text appears onto the display of the emergency

panel, press the embedded button G with the aid of a pointy
object (toothpick..)

three flashing lines “---“ will appear on the display. Press the

on/off button of the remote control for confirmation.

The three flashing lines will disappear from the display and the stove

will recognise the new communication address of the remote control.

Recognition will also be confirmed by 4 acoustic sounds.