MCZ Club AIR - Manual (Page 41)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 41
Operation Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
MAN
21:11
FR
OFF
27
23:00
MAX °C
26 °C
5.6. Various settings
5.6.1. Room ventilation
In all 4 operating modes described above you can adjust the room
ventilation as desired. Simply follow this basic operation: from the basic
display press button D to enter the VENTILATION adjustment setting
(figure 6). At this point, press button C to set the preferred ventilation
setting by choosing one of the 5 available levels, independently of the
flame level. You can also select the "auto" option that automatically
links the room ventilation speed to the flame level.
Summary:
flame at 1 > ventilation at 1; flame at 3 > ventilation at 3: flame at 5 >
ventilation still at 3 (to make the operation quieter than automatic
mode).
In appliances with 2 room fans (comfort air models), you can use the D
key to scroll through and set the speed of each individual fan (identified
as 1 and 2 above the level bars).
N.B.: If you purchase a replacement remote control and need to
change the default settings, proceed as follows: with the
remote control switched on, press the D + E keys
simultaneously for 10 sec (until the flashing number appears).
Press the C key and select 1 or 2 depending on the setting
required by the appliance you wish to operate with the remote
control, then press E to confirm.
5.6.2. Sleep function
The sleep function allows you to quickly set a time at which the product
must shut down. This function is only available in MAN and AUTO
mode. The sleep function is set as follows: from the VENTILATION
adjustment setting (press button D - see previous paragraph), press
button D again to enter the SLEEP adjustment setting. Use button C to
adjust the shut down time in 10 minute steps. Use button D or E to
confirm the setting and return to the basic display which will continue to
show the time of shut down from the sleep function (figure 7).
To disable the SLEEP function simply access the adjustment setting,
decrease the time until dashes appear and confirm.
FIG.6
FIG.7