Epson DFX-9000 - Manual (Page 29)

Paper Handling 29
2
2
2
2
2
2
2
2
2
2
2
2
Adjusting the Paper Position
You can adjust the top-of-form position as well as the printing
position at any point on the page by using the Micro Feed, and
Top of Form buttons. The printer then remembers the new
top-of-form position. When you use the optional pull tractor, you
can adjust the paper position as described below.
Note:
The printing position (based on the top-of-form position) is controlled
by your software. To change the print position, adjust your software’s
print settings. Use the following procedure only if your software does
not allow print position adjustment.
Adjusting the top-of-form position
The top-of-form position is the position to which the printer feeds
the paper when it loads it or performs a form feed. This position
is important because it determines where the printing begins on
each page. If the printing is too high or low on the page, you can
adjust the top-of-form position either permanently or temporarily
depending on how you use the Top of Form button.
❏ When you want to permanently change the top-of-form
position, you enter the top-of-form mode using the Top of
Form control panel button. The printer remembers the new
top-of-form position even after the printer is turned off, reset,
or initialized. (The printer remembers separate top-of-form
positions for the front and rear tractors.)
❏ When you want to temporarily change the top-of-form
position, you adjust the position using the Micro Feed
buttons during pause status without entering top-of-form
mode. The printer remembers the temporary top-of-form
position until the next time you load paper, switch tractors,
or turn off the printer.