Epson DFX-9000 - Manual (Page 103)

Control Panel 103
4
4
4
4
4
4
4
4
4
4
4
4
The printer exits the SelecType mode.
Note:
If you turn off the printer prior to exiting the SelecType mode, any
changes you may have made are canceled and not saved.
Changing the settings in the default-setting mode
The following table shows the basic function of each button in the
default-setting mode.
Follow these steps to enter the default-setting mode and change
the settings:
Note:
If you turn off the printer prior to exiting the default-setting mode,
settings that you have set up until you turn off the printer are saved.
1. Make sure paper is loaded and turn off the printer.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. Turn on the printer while holding down the Font button to
enter the default-setting mode. The message Setting mode
appears on the LCD panel.
Button Basic function
ItemU (Font) button Selects the previous menu parameter.
ItemD (Pitch) button Selects the next menu parameter.
SetU (Tear Off) button Select the previous value in the selected menu.
SetD (Top of Form)
button Select the next value in the selected menu.