Epson DFX-9000 - Manual (Page 157)

Options and Consumables 157
6
6
6
6
6
6
6
6
6
6
6
6
❏ Select the printer’s tear-off mode as follows:
1. Make sure printing has finished. Open the paper separator
cover. You see the perforation cutter’s tear-off edge.
2. Press the Tear Off button to enter tear-off mode. The printer
feeds the paper’s perforation to the perforation cutter’s
tear-off edge.
3. If the paper is not aligned with the tear-off edge, adjust the
tear-off position by pressing the Micro Feed buttons.
4. Press the Tear Off button again. The printer cuts off your
printed document and feeds the fresh paper back to the
top-of-form position.
Switching tractors
To switch tractors when the perforation cutter is installed, follow
these steps:
1. Make sure the printer is turned on. If you are in the middle of
printing a document, wait for the printer to finish printing
before you switch tractors.
2. If no paper is loaded in the tractor you want to use, load paper.
See “Loading Paper onto the Front Tractor” on page 15 or
“Loading Paper onto the Rear Tractor” on page 22 for
instructions.
3. Press the Front/Rear button to switch to the other tractor. The
printer cuts off the printed document, feeds the paper on the
tractor backward to the standby position, and then advances
the paper on the other tractor to the loading position.