Group policy setting items – Epson WorkForce Pro WF-R8590 DTWF User Manual

Page 21

Group Policy Setting Items

Items

Settings and Explanation

Enable this Group Policy

You can enable or disable a group policy.

Access Control

Configure a control method for traffic of IP packets.

Permit Access

Select this to permit configured IP packets to pass through.

Refuse Access

Select this to refuse configured IP packets to pass through.

IPsec

Select this to permit configured IPsec packets to pass
through.

Local Address(Printer)

Select an IPv4 address or IPv6 address that matches your network environment. If an IP
address is assigned automatically, you can select Use auto-obtained IPv4 address.

Remote Address(Host)

Enter a device's IP address to control access. The IP address must be between 0 and 43
characters. If you do not enter an IP address, all addresses are controlled.

Note:
If an IP address is assigned automatically (e.g. assigned by DHCP), the connection may
be unavailable. Configure a static IP address.

Method of Choosing Port

Select a method to specify ports.

Service Name

If you select Service Name for Method of Choosing Port, select an option.

Transport Protocol

If you select Port Number for Method of Choosing Port, you need to configure an
encapsulation mode.

Any Protocol

Select this to control all protocol types.

TCP

Select this to control data for unicast.

UDP

Select this to control data for broadcast and multicast.

ICMPv4

Select this to control ping command.

Administrator's Guide

Using the Printer in a Secure Network