Installing the control module – Enterasys Networks 8000/8600 User Manual
Page 77
Enterasys X-Pedition 8000/8600 Getting Started Guide
65
Installing the Hardware
Installing the Control Module
The primary control module always resides in the CM slot. If you need to replace the primary
control module in the CM slot, or you want to install a redundant control module in slot CM/1, use
the following procedure (you will need a #2 Phillips screwdriver to perform this procedure). The
primary control module must be installed in slot CM. The redundant control module must be
installed in slot CM/1. (See Chassis
for information about the chassis slots.)
shows an example of how to install a control module. The procedure following the figure
describes how to do this.
Figure 30. Installing a Control Module
To install the control module:
1.
If a coverplate is installed over the control module slot (slot or CM/1 only), use the #2 Phillips
screwdriver to remove it.
2.
Slide the control module all the way into the slot, firmly but gently pressing to ensure that the
pins on the back of the control module are completely seated in the backplane.
Note:
Make sure the circuit card (and not the metal plate) is between the card guides, as shown
in
. Check both the upper and lower tracks.
3.
Use the #2 Phillips screwdriver to tighten the captive screws on each side of the control module
to secure it to the chassis.
4.
When you are ready to attach the management cables to the control module, review the cable
specifications under SSR-CM2B-64, SSR-CM3-128, and SSR-CM4-256
10/100 Mgmt
Console
SSR-8
SSR-CM2-64
CONTROL MODULE
Card Guides
Circuit Card
Metal Plate