Enterasys Networks 5H1XX - Manual (Page 78)

Using a Mirror Port for Analysis
7-18 Device Control Menu Screens
7.6 USING A MIRROR PORT FOR ANALYSIS
You can mirror traffic from any source port to a target port for real-time analysis. You can then
attach a logic analyzer or RMON probe to the target port and study the traffic crossing the source
port in a completely unobtrusive manner. When mirroring port traffic, note that the target port must
be configured in the same VLAN and be operating at the same speed as the source port. (Refer to
Section 7.11 for information on configuring virtual VLANs.) If the target port is operating at a
lower speed, the source port will be forced to drop its operating speed to match that of the target
port.
Use the Mirror Port Configuration screen ( Figure 7-10 ) to designate a single port pair (source and
target ports) for mirroring.
Figure 7-10 Mirror Port Configuration Screen
Designated Bridge (ID) The priority and MAC address of the device through which
this port must communicate to reach the root of the
spanning tree.
Designated Port (ID) The priority and number of the port on the designated
bridging device through which this switch must
communicate with the root of the spanning tree.
Parameter Description
Mirror Source Port : 1
Mirror Target Port : 2
Status : DISABLED
3583_30