Enterasys Networks 5H1XX - Manual (Page 45)

Changing the Network Configuration
Management Setup Menu Screens 6-3
6.2 CHANGING THE NETWORK CONFIGURATION
Use the Network Configuration Menu screen ( Figure 6-2 ) for any of the following:
• Access the screens needed to set the bootup option.
• Configure the switch’s Internet Protocol (IP) parameters.
• Enable the on-board Web Agent.
• Set the number of concurrent Telnet sessions allowed.
The screen shown below is described in the following table.
Figure 6-2 Network Configuration Menu Screen
Startup Configuration Used to disable the extended system diagnostics during
system bootup routine for faster bootups. For details, refer to
Section 6.6 .
TFTP Download Downloads new version of firmware to update your system
(in-band). For details, refer to
Section 6.7 .
Selection Description
IP Configuration
IP Connectivity Test (Ping)
HTTP Configuration
MAX Number of allowed Telnet sessions (1-4) : 4
Physical Address : XX-XX-XX-XX-XX-XX
3583_10