Enterasys Networks 5H1XX - Manual (Page 48)

Changing the Network Configuration
6-6 Management Setup Menu Screens
6.2.2 IP Connectivity Test (Ping)
Use the IP Connectivity Test screen ( Figure 6-4 ) to see if another site on the Internet can be
reached. The screen parameters are described in the following table.
Figure 6-4 IP Connectivity Test Screen
Parameter Description
IP Address IP address of the site that you want to ping.
Test Time The number of ICMP echo requests to send to the specified
site. Range: 1~1000
Interval The interval (in seconds) between pinging the specified site.
Range: 1~10 seconds
Success/Failure The number of times the specified site has or has not
responded to pinging.
[Start] command This field is used to initiate the ping. To ping an address,
highlight [Start] using the arrow keys, then press ENTER.
IP Address: 0.0.0.0
Test Time : 1 Interval : 3
Success : 0 Failure : 0
[Start]
3583_12