1 ip configuration, Ip configuration -4, Ip configuration screen – Enterasys Networks 5H1XX User Manual
Page 46: Ip configuration
Changing the Network Configuration
6-4
Management Setup Menu Screens
6.2.1
IP Configuration
Use the IP Configuration screen (
) to set the bootup option, or configure the switch’s IP
parameters. The screen shown below is described in the following table.
Figure 6-3
IP Configuration Screen
Parameter
Description
IP Configuration
Used to set the bootup option, or configure the switch’s IP
parameters.
IP Connectivity Test (Ping)
Used to test IP connectivity (Ping) to a specified device.
HTTP Configuration
Used to enable the Web Agent.
MAX Number of Allowed Telnet
Sessions (1-4)
The maximum number of Telnet sessions allowed to
simultaneously access the agent module.
Physical Address
Physical address of the agent module.
Interface Type
: Ethernet
IP Address
:
XXX.XXX.XXX.XXX
Subnet Mask
: XXX.XXX.XX.XX
Gateway IP
: XXX.XXX.XX.X
IP State
: USER-CONFIG
3583_11