Epson EQUITY 386SX/16 PLUS - Manual (Page 34)

When the system has successfully completed its self test, you
see the following prompt:
Press to start SETUP
Do not press any key yet. If MS-DOS has already been
installed on your system, you’ll see a prompt to enter the
date. (For information about loading the operating system,
see your MS-DOS Installation Guide or Reference Manual.)
If there is no operating system on your computer, you see an
error message. Ignore the message for now. Follow the
instructions below to turn off the computer and then go on
to Chapter 2 for instructions on running the SETUP program.
Turning Off the Computer
When you are ready to turn off your system, reverse the
sequence of steps you followed to turn it on. Turn off the
computer first, then turn off the monitor and any peripheral
devices.
Now go on to Chapter 2 and follow the instructions to run
the SETUP program.
1-18 Setting Up Your System