Epson EQUITY 386SX/16 PLUS - Manual (Page 159)

2. Remove the retaining screw securing the hard disk drive
mounting plate to the computer and set it aside.
3. Tilt the hard disk drive slightly to the right, away from
the subassembly, and lift it out of the vertical mounting
area. Turn it over and set it on top of the subassembly
with the gray mounting plate facing up. Since the drive is
attached to its cables, make sure you do not try to move
it too far away from the subassembly as you turn it.
Installing and Removing Disk Drives
B - 2 5