Epson EQUITY 386SX/16 PLUS User Manual
Page 123
Align the connector with the socket so the tab on the
connector lines up with the notch in the socket. Make
sure the holes in the connector fit over all the pins in the
socket and then push in the connector.
Caution
If you do not correctly align the holes with the pins,
you could severely damage your computer when you
push in the connector.
7. Now connect the hard disk drive cable in the same
manner.
8.
To replace the front panel, fit the three ridged tabs on its
bottom edge into the three notches on the lower edge of
the
computer, as shown below.
tabs
9. Tilt up the front panel until the clips on the top of the
panel touch the computer. Then push on the top of the
panel until it clicks into place.
10. Follow the steps on page 5-40 to replace the computer’s
cover. Then see “Post-installation Setup” on page 5-42 for
instructions on configuring your computer.
Installing and Removing
Options
5-39