Tests selected using the – Epson EQUITY 386SX/16 PLUS User Manual

Page 197

You can stop testing at any time and return to the main
menu by holding down

Ctrl

and pressing

Break. The

program

completes the current test before it stops.

You must enter certain parameters to run the hard disk and

diskette drive tests. If you use

to select these tests, the

program prompts you for the parameters immediately. If you

use

F4,

the program prompts you for the parameters during

the first pass of the test. If you perform the tests more than

once, the program uses the same parameters for each pass.

If you selected Passbound testing, the program displays the
pass number on the right side of the screen above the Run

time parameters window. For example:

Pass :

00001

If you entered Y at the

Wait on

error prompt, the

program pauses if an error occurs. When you press

Enter,

the

program continues testing,

Note

Tests selected using the

and

keys remain selected

until you cancel the selection. Be sure to press

to cancel

all selections when you are finished running each set of

tests.

Performing System Diagnostics

C-9