Connecting the hard disk drive cables, B-18 – Epson EQUITY 386SX/16 PLUS User Manual
Page 152
Connecting the Hard Disk Drive Cables
Follow these steps to lift up the subassembly and connect the
drive cable to the main system board:
1. Remove the front panel from the computer by lifting up
slightly on the three clips at the top of the panel and
tilting it toward you. Then set it aside.
2. To lift the subassembly from the front of the computer,
place your thumbs under the diskette drive and grasp the
top edge of the computer with the rest of your fingers, as
shown in the following illustration. (If you have a
diskette drive installed in the lower horizontal drive bay,
place your thumbs underneath that drive instead.) Then
lift up the subassembly with your thumbs.
B - 1 8
Installing and Removing Disk Drives