Epson EQUITY 386SX/16 PLUS User Manual
Page 102
Follow these steps to remove the subassembly:
5-18
1. Remove the front panel from the computer by lifting up
slightly on the three clips at the top of the panel and
tilting it toward you. Then set it aside.
clips
2.
If you have a hard disk drive, the drive cable is connected
to the main system board on the left side of the
subassembly, as shown below.
diskette
drive cable
Installing and Removing Options
See also other documents in the category Epson Computers:
- ACTIONPC 5000 (12 pages)
- Endeavor (197 pages)
- 20040 (251 pages)
- EQUITY 386SX/20 PLUS (6 pages)
- S1C33210 (559 pages)
- 3865X Plus (337 pages)
- 2000 (231 pages)
- 2000 (129 pages)
- 486SX (233 pages)
- EISA Desktop (184 pages)
- 386 (218 pages)
- Equity 286 PLUS (263 pages)
- 10020 (238 pages)
- Equity II (79 pages)
- Equity II (151 pages)
- EQUITY Y14499113001 (139 pages)
- Equity 320SX PLUS (230 pages)
- EL 3S/33 (117 pages)
- EQUITY 3865X/20 PLUS (269 pages)
- Endeavor 468C (187 pages)
- Equity Ie Q50188015-1 (147 pages)
- LT-286 (188 pages)
- 386/25 (326 pages)
- 386SX (284 pages)
- Endeavor power (SPEED) hard disk diskette WG (8 pages)
- 486 UC+ (9 pages)
- Endeavor WG (201 pages)
- S1C63000 (152 pages)
- I+ (139 pages)
- LT - 286e (60 pages)
- LT - 286e (161 pages)
- 486SX EN (6 pages)