Epson EQUITY 386SX/16 PLUS - Manual (Page 111)

4. Remove the SIMMs in the sockets closest to the left side
of the main system board first. Use your fingers or two
small screwdrivers to pull away the tabs that secure the
SIMM at each end. Be careful not to pull the tabs too far,
or they may break.
As you pull away the tabs, the SIMM falls to the left.
When the SIMM is at an angle, release the tabs and
carefully remove it from the socket.
5. Repeat step 4 for each SIMM you need to remove.
6. Replace the subassembly. See page 5-32.
7. Follow the steps on page 5-40 to replace the computer’s
cover. Then see “Post-installation Setup” on page 5-42 for
instructions on configuring your computer for use with
your decreased memory.
Installing and Removing Options 5-27