Magnum Energy RD Series - Manual (Page 10)

Page 4
©
2010 Magnum Energy, Inc.
Introduction
Figure 1-3, Left Side Features
The left side of the RD Series is equipped with the following features (see Figure 1-3):
13
Exhaust Air Vent - ventilation openings that allow heated air to be removed by the
internal cooling fan.
14
Model/Serial Number Label - includes model/serial number information, date of
manufacture, and inverter and charger specifi cations. See the RD Specifi cations in
Appendix A for more information and the different models that are available.
15
AC Access Cover - provides access to the internal AC wiring terminal block. This terminal
block is used to hardwire all inverter AC input and output wiring connections. Remove the
two screws to access the AC wiring terminal block.
16
Input Circuit Breaker - this circuit breaker protects the unit’s internal charger wiring
and pass-thru relay while in Standby Mode. This circuit breaker will pop out when it
opens. Press in to reset. This input circuit breaker is not branch-circuit rated, therefore,
branch-circuit rated breakers must be installed in the inverter’s input wiring.
CAUTION: The inverter’s internal AC transfer relay is rated for 30 amps per leg. The
pass-thru current must be no greater than 30 amps per leg or damage to the relays
may occur.
M
ODEL
/S
ERIAL
N
UMBER
L
ABEL
AC A
CCESS
C
OVER
E
XHAUST
A
IR
V
ENTS
(
BACK SIDE
)
I
NPUT
C
IRCUIT
B
REAKER
13
16
14 15