LW Scientific OmniVID - Manual (Page 27)

Quick Start Guide
for Windows 98/XP
1 Open CD tray and insert the OmniVID 98/XP installation CD.
2 Either auto-run the OmniVID installation CD or go to My
Computer and select the CD.
3 From the main CD menu select Micro Driver V 1.0 and complete
the installation.
4 After installation is complete, select Microcap V 2.0 from the main
CD menu and complete the installation.
5 After both Micro Driver V 1.0 and Microcap V 2.0 are installed,
plug the included USB cable into the OmniVID camera and plug it
into an available USB port on the computer. Wait for Windows XP to
install the OmniVID camera drivers.
6 After the camera is plugged into computer, start up Micro Cap V
2.0 from either the desktop or by going to the start menu and
selecting Micro Cap V 2.0 from the All Programs list.
7 If all instructions have been followed, the camera should be up
and running.
Quick Start Guide
for Windows Vista
1 Open CD Tray and insert the OmniVID Vista installation CD.
2 Either auto-run the OmniVID installation CD or go to My
Computer and select the CD.
3 From the main CD Menu select Micro Driver V 1.0 and complete
the installation.
4 After installation is complete, from the main CD menu select
Microcap V 2.0. and complete installation.
5 After both Micro Driver V 1.0 and Microcap V 2.0 are installed,
plug the included USB Cable into the OmniVID camera and plug it
into an available USB port on the computer. Wait for Windows Vista
to install the OmniVID camera drivers.
6 After the camera is plugged into the computer, start up Micro Cap
V 2.0 from either the Desktop or by going to the start menu and
selecting Micro Cap V 2.0 from the All programs list.
7 If all instructions have been followed, the camera should be up
and running.
MKT-7.5.3-L-051 | Rev 0