LW Scientific OmniVID - Manual (Page 17)

Three are two sets of power source in microscope, one is for
the camera, and the other is for the illumination. The switches are at
the back of the microscope. To operate the microscope, both
switches must be on.
When USB cable is plugged into the camera, the LCD screen will be
switched off
When the camera is operated with a computer, the SD memory card
is not necessary and all the data will be stored on the computer
Remote control is not applicable when operating the camera with a
computer
Operations when connected with a TV
Live images can be seen on a TV screen if the camera is connected to a
TV
Connection operations with TV
Plug the TV cable into
「TV OUT」 port of the camera and video input
port of the TV
At this moment, the preview image shown on the LCD will be
displayed on the TV screen, the LCD will be turned off
Use PLAY mode you can play back the recorded images and videos
on the TV
All other operations are the same as operating on the camera
Notice:
When the camera is connected with a TV, the remote control can still
be applicable
This camera supports both of the most popular TV formats, NTSC
and PAL
The connection operation with a projector is the same as the TV
Connection operations with Printer
Camera can be connected to a printer that supports PictBridge
function to print out the recorded images without the need of a computer
Connection operations
Switch on both the camera and the printer
SD card with the recorded images must be installed
Connect the camera with the print using the USB cable
16