LW Scientific Epi Lumin Module - Manual

P. 770.270.1394 F. 770.270.2389 865 Marathon Parkway Lawrenceville GA 30046
Instruction Manual
Epi Module Epi Module
Installing Module
Loosen the head retention screw, remove the microscope head, and set it aside on a flat stable
surface.
Place the Lumin Epi-Module onto the body in place of the head. For i4 series microscopes, align the
“groove” in the flange on the bottom of the module with the “tab” on the flange on the scope. Rotate
the module until properly seated.
Position the module so that it is straight with the body of the microscope. Once it is in place, tighten the
module retention screw on the right side of the body. Next, lace the head of the microscope onto the
upper flange of the Epi-Module. For i4 series scopes, align as in Step 2.
1
2
3