LinPlug Octopus - Manual (Page 44)

Unison/Glide
The Octopus' Unison/Glide module contains a group of controls related to
the instrument's polyphonic capabilities as well as its portamento settings.
The Unison/Glide module is located on the right side of the front panel
below the waveform display and above the Envelope Matrix.
The Unison/Glide module contains the following controls: Transp
(Transpose), Voices, Unison, Porta (Portamento), Slide, Detune and Bend
Up/Bend Down. These controls are described below.
Transp (Transpose)
The Transpose control is used to set the overall pitch (in semitones) of the
instrument relative to the input trigger. For example, if the Transpose
control is set to 5, then the entire instrument's output will be transposed
upwards by 5 semitones. The available range is -24 to +24 semitones.
Voices
The Voices control is used to set the number of voices (otherwise known as
polyphony) available within the instrument. The Voices control has a range
of 1 to 12 voices.
Unison
The Octopus has a Unison mode in which the instrument's oscillators are
detuned to create extremely fat, rich sounds. When in Unison mode, the
42 Manual