Linkskey LKV-IPM01 - Manual (Page 20)

KLE User Guide R1.2
Step 4. Go to the LAN TCP/IP page on the KLE Browser Management Interface and
modify your IP settings. Refer to Section 4.12, LAN TCP/IP – Port and IP Settings.
Step 5. Apply the new setting by clicking Apply Settings.
Step 6. Verify KLE’s network connection.
Connect to KLE by Web Management Interface using the new IP address.
Note that the IP address should be followed immediately by a colon and the port
base +8 for port number,
https://:.
For example, if the IP address is 192.168.1.7 and the port base number is 5900,
then you should enter
https://192.168.1.7:5908
Remember that it’s a secure SSL encrypted connection, so you should type “https” instead of the usual
“http”. Otherwise, the connection will not be established.
2.5 Configure port base setting for KLE
If you are satisfied with the default port base setting as 5900, you can skip this section.
The default port base for KLE connection is set at 5900. This means it will use port
5900 (port base) for viewer connection and port 5908 (port base + 8) for https web
browser connection.
– used for viewer connection
– used for secure browser connection
- - 16