Yaskawa P7B Drive Bypass - Manual (Page 102)

Programming 5 - 8
" Options - G, H, L, Q, or V and P "Serial Communications" and "Pneumatic Pressure Trans-
ducer"; Bypass with serial communication for run/stop control and speed monitoring, with pneu-
matic input for speed control:
Hand mode speed command from Keypad/Operator.
Auto mode speed command input signal from the pneumatic transducer, or 4-20 mA applied to Drive terminal A2.
Auto mode run/stop command for Drive from serial communication.
Auto mode run/stop contact closure for Bypass applied to terminals TB1-3 and TB1-4.
" Options - G, H, L, Q, or V and S "Serial Communications" and "Speed Pot."; Bypass with serial
communication for control, with hand mode speed potentiometer:
Hand mode speed command from speed potentiometer.
Auto mode speed command input signal from serial communication.
Auto mode run/stop command for Drive from serial communication.
Auto mode run/stop contact closure for Bypass applied to terminals TB1-3 and TB1-4.
Significant
Parameter Setting
Result
b1-01 = 0: Operator Speed command source = Keypad/Operator (d1-01)
H3-08 = 2: 4-20 mA (default) Terminal A2 is programmed for 4-20 mA (Transducer output is 4-20 mA)
(Note – Control PCB DIP switch S1-2 must also be ON)
H3-09 = 2: Aux Reference (default) Terminal A2 function is set to be a speed command input. This setting also
gives terminal A2 priority over d1-02 for “preset speed 2”, see
Programming Manual.
H1-02 = 3: Multi-Step Ref 1
S4 must be jumpered to SN A terminal S4 input contact closure selects A2 as “preset speed 2” speed
input. The S4 input is jumpered to SN, therefore it is always closed.
H1-03 = 6C: Com/Inv Sel 2 A terminal S5 input contact closure allows b1-01 to select d1-01 (keypad)
as a preset speed. An open contact selects serial com for the run/stop
command (the serial com speed command is overridden by the preset
speed above). This input contact is closed when H/O/A = Hand.
H1-04 = 4: Multi-Step Ref 2 (default)
S6 must be jumpered to S5 A terminal S6 input contact closure selects d1-04 (keypad) as a speed
input. When open, the speed command is determined by “preset speed 2”.
This input contact is closed when H/O/A = Hand.
Significant
Parameter Setting
Result
b1-01 = 1: Terminals (default) Speed command source = Terminals
H3-13 = 0: Main Fref TA1 (default) Specific speed command source = Terminal A1
H1-03 = 6C: Com/Inv Sel 2 A terminal S5 input contact closure allows b1-01 to select terminals and
the speed pot. as the speed command. An open contact selects serial com
for speed command and run/stop. This input contact is closed when H/O/A
= Hand.