Yaskawa YASNAC PC NC I/O Signal Function Manual - Manual (Page 10)

1 - 3
YASNAC PCNC I/O Signal Function Manual Chapter 1: Feed Function
1.2 No. 2 G00 Mode Signal
Axis feed in the G00 mode is controlled by the setting for parameters, i.e. feedrates, acceleration/
deceleration, time constants and S-curve accel/decel coefficients. This funtion has two sets of
parameters related to the execution of the G00 code to control feedrate, and the effect of the
accel/decel time constant and S-curve accel/decel according to theinput signal (G002X to G0025).
1.2.1 No. 2 G00 Mode Input Signals (#31019 to #31014)
These signals change over the control mode between the G00 and the second G00 control
mode for the individual axes (X-axis to the 5th-axis).
If these signals are “open” the G00 control mode is called.
If these signals are “closed”, the second G00 control mode is called.
1.2.2 No. 2 G00 Mode Input Signals (#36280 to 36284)
These signals are second G00 control mode outptut signals for the individual axes
(X-axis to the 5th-axis).
If these signals are “open” the G00 control mode is called.
If these signals are “closed”, the second G00 control mode is called.
No. 2 G00 Mode Input G002X to G0025 #31010 to #31014
No. 2 G00 Mode Output G002XS to G0025S #36280 to #36284