1 displaying the module configuration window – Yaskawa JAPMC-CM2304-E User Manual
Page 48
4.1 Displaying the EtherNet/IP Transmission Configuration Window
4.1.1 Displaying the Module Configuration Window
4-2
4.1 Displaying the EtherNet/IP Transmission Configuration Window
This section describes how to open the Module Configuration window from the MPE720, open the EtherNet/IP
Transmission Configuration window from the Module Configuration window, and set the transmission definition
for the EtherNet/IP Module.
4.1.1 Displaying the Module Configuration Window
Use the following procedure to display the Module Configuration window.
( 1 ) MPE720 Ver. 6
1.
Start the MPE720 on the personal computer connected to the Machine Controller, and open the project
file.
For information on starting the MPE720, refer to Machine Controller MPE720 Programming Device Ver. 6
User's Manual (Manual No.: SIEPC88070030).
2.
Select Setup - Module configuration in the Launcher, or double-click the Module configuration icon
in the system subprogram.
The Engineering Manager will launch and the Module Configuration window will open
(refer to page 4-3).
( 2 ) MPE720 Ver. 5
1.
Start the MPE720 on the personal computer connected to the Machine Controller and use the File Man-
ager to log in and go online with the application for the Machine Controller.
For information on starting the MPE720 and logging on, refer to MPE720 Software for Programming Device
User's Manual (Manual No.: SIEPC88070005).
2.
Double-click the Module Configuration icon in the Definition Folder.
The Engineering Manager will launch and the Module Configuration Window will open
(refer to page 4-3).