SMA SMC 6000TL Installation - Manual (Page 56)

Opening and Closing SMA Solar Technology AG
56 SMC6-8TL-IEN101040 Installation Guide
2. Close all unnecessary DC inputs as described in section 5.4.4 ”Connecting the PV Generator
(DC)” (page 34) to seal the inverter.
3. Check the Electronic Solar Switch for wear, as
described in section 8.2 and attach it firmly.
4. Switch on the line circuit breaker.
5. Check whether the display and the LEDs indicate
normal operating mode (see section
6 ”Commissioning” (page 46)).
☑ The inverter is now closed and in operation.
NOTICE!
Manipulating the connector in the handle can damage the Electronic Solar
Switch.
The connector inside the handle must remain movable in order to ensure proper contact.
Tightening the screw voids all warranty claims and creates a fire risk.
• Do not tighten the connector screw in the Electronic Solar Switch handle.
NOTICE!
Damage to Electronic Solar Switch.
If not plugged correctly, the Electronic Solar Switch can be damaged by high voltages.
• Connect the holder firmly on to the socket of the Electronic Solar Switch.
• Make sure that the device is securely in place.