SMA SB 3000-US - Manual (Page 29)

SMA America, LLC 5 Mounting
Installation Manual SB30-40-US-IA-en-34 29
5.3 Mounting the Wall Mounting Bracket on a Stone Wall
Additional required mounting material (not included in the scope of delivery):
☐ 3 screws suitable for the foundation.
☐ 3 washers suitable for the screws.
☐ 3 screw anchors suitable for the foundation and for the screws.
1. Position the wall mounting bracket at the installation location. Tip: The bottom end of the wall
mounting bracket reaches approximately to the bottom corner of the inverter.
2. Align the bracket with a spirit level.
4. Use the wall mounting bracket as a template. For this purpose, mark the oblong holes at the
extreme left and right as well as the lowest oblong hole in the middle of the wall mounting
bracket.
5. Remove the bracket from the wall.
6. Bore drill holes at the markings.
7. Insert suitable screw anchors into the drill holes.
8. Insert screws with washers through the oblong
holes of the wall mounting bracket into drill holes.
9. Tighten the screws. Ensure that no screws are loose.
10. Ensure that the wall mounting bracket is firmly positioned.
3.
Danger to life from electric shock due to damage to electric lines
Electric lines may be located behind the installation points which can be damaged when
mounting the inverter.
• Ensure that no electric lines are located behind the installation points.