HEIDENHAIN PROFINET - Manual (Page 21)

Configuration example
21
3.2 Setting encoder configuration
When the GSD file has been installed the supported encoder
types can be found in the HW Configuration under PROFINET IO-
>Additional Field Devices->Encoders->JH Group PROFINET En-
coders. Select either multi turn 25 bit or single turn 13 bit encoder,
dependent on the type of encoder to be configured. Drag and
drop the encoder onto the PROFINET IO system as shown in the
picture below. In the example below one 25 bit multiturn encoder
was chosen. If more than one encoder shall be configured, then
the following steps need to be done once for each device.
Figure 4 Encoder configuration