HEIDENHAIN TNC 620 (73498x-02) ISO programming - Manual (Page 90)

Programming: Fundamentals, file management
3.2 Opening programs and entering
3
90
TNC 620 | User's Manual for DIN/ISO Programming | 5/2013
Opening a new part program
You always enter a part program in the
PROGRAMMING AND
EDITING mode of operation. An example of program initiation:
Select the
PROGRAMMING mode of operation
Call the file manager: Press the PGM MGT key
Select the directory in which you wish to store the new program:
.I
Enter the new program name and confirm your
entry with the ENT key.
Select the unit of measure: Press the MM or INCH
soft key. The TNC switches the screen layout and
initiates the dialog for defining the
BLK FORM
(workpiece blank)
WORKING PLANE IN GRAPHIC: XY
Enter spindle axis, e.g. Z
WORKPIECE BLANK DEF.: MINIMUM
Enter in sequence the X, Y and Z coordinates of
the MIN point and confirm each of your entries
with the ENT key
WORKPIECE BLANK DEF.: MAXIMUM
Enter in sequence the X, Y and Z coordinates of
the MAX point and confirm each of your entries
with the ENT key
Example: Display the BLK form in the NC program
%NEW G71 *
Program begin, name, unit of measure
N10 G30 G17 X+0 Y+0 Z-40 * Spindle axis, MIN point coordinates
N20 G31 X+100 Y+100 Z+0 * MAX point coordinates
N99999999 %NEW G71 *
Program end, name, unit of measure
The TNC automatically generates the first and last blocks of the
program.
If you do not wish to define a blank form, cancel the
dialog at
Working plane in graphic: XY by pressing
the DEL key.
The TNC can display the graphics only if the shortest
side is at least 50 µm long and the longest side is no
longer than 99 999.999 mm.