HEIDENHAIN TNC 620 (73498x-02) ISO programming - Manual (Page 410)

Manual operation and setup
14.6 Using 3-D touch probes (Touch Probe Function software option)
14
410
TNC 620 | User's Manual for DIN/ISO Programming | 5/2013
14.6 Using 3-D touch probes (Touch Probe
Function software option)
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Function Soft key Page
Calibrating the effective length 418
Calibrating the effective radius 419
Measuring a basic rotation using a
line 423
Setting a datum in any axis 425
Setting a corner as datum 426
Setting a circle center as datum 428
Setting the centerline as datum 430
Touch probe system data
management See User’s
Manual for
Cycles
For more information about the touch probe table,
refer to the User’s Manual for Cycle Programming.